1. Tech

Your suggestion is on its way!

An email with a link to:


was emailed to:

Thanks for sharing About.com with others!

Linux / Unix Command: setbuffer
Command Library


setbuf, setbuffer, setlinebuf, setvbuf - stream buffering operations  


#include <stdio.h>

void setbuf(FILE *stream, char *buf);
void setbuffer(FILE *stream, char *buf, size_tsize);
void setlinebuf(FILE *stream);
int setvbuf(FILE *stream, char *buf, int mode , size_t size);  


The three types of buffering available are unbuffered, block buffered, and line buffered. When an output stream is unbuffered, information appears on the destination file or terminal as soon as written; when it is block buffered many characters are saved up and written as a block; when it is line buffered characters are saved up until a newline is output or input is read from any stream attached to a terminal device (typically stdin). The function fflush(3) may be used to force the block out early. (See fclose(3).) Normally all files are block buffered. When the first I/O operation occurs on a file, malloc(3) is called, and a buffer is obtained. If a stream refers to a terminal (as stdout normally does) it is line buffered. The standard error stream stderr is always unbuffered by default.

The setvbuf function may be used on any open stream to change its buffer. The mode parameter must be one of the following three macros:

line buffered
fully buffered

Except for unbuffered files, the buf argument should point to a buffer at least size bytes long; this buffer will be used instead of the current buffer. If the argument buf is NULL, only the mode is affected; a new buffer will be allocated on the next read or write operation. The setvbuf function may only be used after opening a stream and before any other operations have been performed on it.

The other three calls are, in effect, simply aliases for calls to setvbuf. The setbuf function is exactly equivalent to the call

setvbuf(stream, buf, buf ? _IOFBF : _IONBF, BUFSIZ);

The setbuffer function is the same, except that the size of the buffer is up to the caller, rather than being determined by the default BUFSIZ. The setlinebuf function is exactly equivalent to the call:

setvbuf(stream, (char *)NULL, _IOLBF, 0);


The function setvbuf returns 0 on success. It can return any value on failure, but returns nonzero when mode is invalid or the request cannot be honoured. It may set errno on failure. The other functions are void.  


The setbuf and setvbuf functions conform to ANSI X3.159-1989 (``ANSI C'').  


fclose(3), fflush(3), fopen(3), fread(3), malloc(3), printf(3), puts(3)

Important: Use the man command (% man) to see how a command is used on your particular computer.

>> Linux/Unix Command Library

>> Shell Command Library

Explore Linux
By Category
    linuxLinuxcomputeTechb0502bb1540001006c84963cb0502bb1540002006c818e0ahttp://linux.about.comod526F6F74132058liveGary Newelllinuxguide3TO004KpzNIP11970-01-0110/od/index.htm0526F6F741approved/od
  1. About.com
  2. Tech
  3. Linux

©2016 About.com. All rights reserved.