8.1 USB Bus
The USB (Universal Serial Bus) is a high speed bus on an external cable that plugs into a PC. The external bus cable has its own communication protocols and doesn't use any IRQs, I/0 addresses (or other bus-resources). Communication is by packets, something like the Internet, only there are time-slice allocations which prevent any one device from hogging the bus if other devices need it. There are free time slots which allow every device to send a short message to the bus controller without any need for IRQs on the bus.
However, the USB bus controller inside the PC does have an IRQ and an address on the PCI bus (or ISA) which are used for communication between the CPU and all devices on the USB. Thus there's no resource allocations needed for the individual devices on the USB. One could also think of this as all devices on the USB sharing the one interrupt and address. If a device is on the USB it needs a driver that understands the USB.
But each device on the USB does have an IDs, just like cards do on the PCI bus. So Linux likely maintains a table of these IDs so that device drivers can check them to find their device. The USB also support "hot plug". To find out what is on the USB bus, you could use a general hardware detection tool like "discover" or "hwinfo".
* License
